Hi, I just purchased a used miller thunderbolt 225, thinking it was a AC DC welder. It turned out to be a AC constant current only. Is it possible to tig weld this machine or am I stuck with a buzz box only. I'm not sorry I bought it, it welds great.
Results 61 to 70 of 223
Thread: Dynasty Processes-Set Up
11-19-2009, 01:43 PM #61Junior Member
- Join Date
- Nov 2009
11-19-2009, 01:51 PM #62
Wrong thread Bro- this is for the Dynasty Series machines
Just start a new thread so you'll get some hits
11-19-2009, 05:48 PM #63
11-19-2009, 06:01 PM #64
11-19-2009, 06:11 PM #65
KB did write this though..
"I could probably help if you would give a little better explanation of your HF problem. The Dynasty's are sensitive in respect to the tig start parameters so it may be as simple as changing a couple of the settings via hidden menu.
but I still can't find a post on what those changes are
11-20-2009, 01:22 PM #66
My 200DX is having some intermittent issues of starting at lower power levels. Like when I want to just ease the power on as apposed to the arc just POPPING on. This is most apparent while in AC mode
11-20-2009, 01:39 PM #67
... on that note I did find one where he said to go in to the Hidden menu and reset the Start amps to say 5amps for thin wall AL.
11-21-2009, 03:34 PM #68
Last edited by KB Fabrications; 11-21-2009 at 06:27 PM.Dynasty 350DX
Dynasty 200DX TigRunner
MM Passport Plus
Spectrum 375 Extreme
08' Trailblazer 302
11-22-2009, 01:03 AM #69
Thanks KB that is what I was looking for.
11-22-2009, 01:24 AM #70