Hey guys I have a 05 maxstar 200 sd that will not weld and shows no ocv from 4 to 10 minutes when starting up miller says may be pc1 board about 4 -450 bucks. Is there any way to confirm what is wrong? I changed the ocv from low to normal which I like but it didnt help It welds good after it warms up sometimes when cold takes alot longer. Afraid it is just going to quit for good one day in middle of job.
I heard once of someplace where you could buy miller pc boards for reasonable price on the net but cant find it.
Any one else had this problem? Any help would be appreciated.
Results 1 to 1 of 1
05-08-2011, 10:43 PM #1
Maxstar 200sd problem with slow ocv starup
Last edited by Weldinman; 05-08-2011 at 11:07 PM.