I am building a new MIG cart for my 211.
The lower frame is .065 wall 1 x 2 and the front axle is solid rectangular.
I made some brackets from 3/16 to bolt the axle to the frame.
I'm wondering if I should employ crush tubes in the design, to keep from crushing the tubing where the axle bracket attaches through the tubing frame?
I'll most likely use 5/16 bolts.
Results 1 to 2 of 2
Thread: Crush Tubes?
04-17-2009, 09:09 AM #1Senior Member
- Join Date
- Oct 2008
Crush Tubes?Millermatic 211 AutoSet w/MVP
Century 110 volt 90/110 MIG-Gone to my son, in Texas
Victor SuperRange OA
Milwaukee Cold Cut Saw
Milwaukee Portable Deep Cut Bandsaw
Milwaukee Hole Hawg
Jet Horizontal/Vertical Bandsaw
Jet MD-18 Mill Drill
Orbit Drill Press
12 Ton Floor Press
2002 E-350 V-10:
1983 F-150 4.9L 6
2004 Honda ST1300
2007 Suzuki LTA400F Quad
1997 Suzuki DR650
04-17-2009, 10:15 AM #2
That prob wouldn't hurt if you can make them...BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below.