It is about 1/2 inch off the ground. Once it is welded up with the punch channel I have not notice sag. I have a couple large section over 6' that has minimal sag.
Results 21 to 23 of 23
04-15-2009, 04:01 PM #21
04-16-2009, 04:32 AM #22Senior Member
- Join Date
- Sep 2008
- southwestern ohio
What would be the problem with geting a piece of C chanel and taking it to a fabrication shop an have them put it on an iron worker to punch square holes in it, would it still sag?
04-16-2009, 12:48 PM #23
I never thought about sag, so I went out and check my largest section that has no ground contact. It is 102" and in the middle it does have a 1/2 in sag after 8 years. It is not noticeable by your eye. You can not go wrong with King ,www.kingmetals.com. Order a parts book and a great Idea/design book.
Last edited by smooth72; 04-16-2009 at 01:00 PM.