buss bar material

[rb455ho]

Does anyone know where I can find some 6101-T61 aluminum in .105" thick. I need to make some buss bars and this is the material required. All my local suppliers look at me like I have a third eye or something!

Thanks Rob

[aametalmaster]

You didn't say the width and length but try here...Bob
http://www.clintonaluminum.com/produ...inum_plate.pdf
http://www.speedymetals.com

[rb455ho]

I will have to shear, bend, punch, notch, etc. Thanks for the link I will check it out!

Thanks Rob

[vin-man welding]

i didn't see any 6101-t61 on ether site.??

[Portable Welder]

What exactly are you doing and why is that specific bus bar so important.

Im currently buiding a crane system and searching for buss duct that can be rolled on a 3'-8" radious.

I just did some testing on some stuff called 110 amp ductil bar made by Conductix and it seems to work OK.

Some other stuff we were looking into was duct-o-bar.

Those are 2 companies that I found to help me with what I needed.

Good luck on finding what you need.

[griff01]

Does anyone know where I can find some 6101-T61 aluminum in .105" thick. I need to make some buss bars and this is the material required. All my local suppliers look at me like I have a third eye or something!

Thanks Rob

http://schupanalum.thomasnet.com/vie...-t61-extruded-

Griff

[griff01]

Does anyone know where I can find some 6101-T61 aluminum in .105" thick. I need to make some buss bars and this is the material required. All my local suppliers look at me like I have a third eye or something!

Thanks Rob

I sent a link to you but the moderators blocked it. ?????????????

Griff

[griff01]

Does anyone know where I can find some 6101-T61 aluminum in .105" thick. I need to make some buss bars and this is the material required. All my local suppliers look at me like I have a third eye or something!

Thanks Rob

http://www.westernamspec.com/Invento...1/6101-t61.asp

Griff

[davedarragh]

Fastenal may have something like that

Dave