Finally finished my table. I based the plans off the table in the project plans section on millers site. I have a rack under the table to store material as long as six feet and six small cubbie holes to store small scrape. The top plate is only 1/8" so I ran additional stringers underneath to help reinforce it. I really wanted to use at least 3/16" plate for the top but it so expensive. To help deal with the heat I'm going keep some scrape 1/4" plate lying around to put between the table and my work. Hopefully this will help to keep from warpping the surface too much.
Results 1 to 4 of 4
Thread: My new table
Threaded View
-
03-01-2006, 09:48 PM #1
Member
- Join Date
- Feb 2006
- Location
- Santa Clara, Ca
- Posts
- 65
My new table
Reply With Quote
