I built a corner table-its almost ready for a krylon makeover. I have a hard time welding FEM. I used 3/32 6013 at 55-65 amps.
Results 1 to 4 of 4
Thread: weekend project
-
02-15-2009, 03:21 PM #1
Member
- Join Date
- May 2008
- Location
- NY
- Posts
- 31
weekend project
Joe in NY
Clarke 131E Arc Welder
HF 4x6 bandsaw
Hitachi 4.5" Grinder
Craftsman Air Compressor
-
02-15-2009, 04:21 PM #2
Member
- Join Date
- May 2008
- Location
- NY
- Posts
- 31
Thanks Reggie, I'll give it a try
Joe in NY
Clarke 131E Arc Welder
HF 4x6 bandsaw
Hitachi 4.5" Grinder
Craftsman Air Compressor
-
02-15-2009, 06:28 PM #3
Junior Member
- Join Date
- Nov 2007
- Posts
- 15
Corner Table
Nice work! Not bad for a weekend project! I find that 3/32" 6013 at about 50-60 amps work well on thin square tube. FEM is a pain for me too! I am going to try reggie's tip! Thanks Reggie!
Take Care,
John
-
02-15-2009, 11:51 PM #4
Member
- Join Date
- May 2008
- Location
- NY
- Posts
- 31
Thanks John.
Joe in NY
Clarke 131E Arc Welder
HF 4x6 bandsaw
Hitachi 4.5" Grinder
Craftsman Air Compressor
Reply With Quote
