The anchor point that allows the saw's angle to be set broke a couple years back and I saved the part in spite of not having access to welding equipment, glad I did. I pre-eated with a heat gun on high for about a minute and set the MM140 to 6/90 but after a blast or two upped it to 7/100. It looks ok. We'll see with use.
Absolutely delighted that I bought this welder!!! I know this isn't a masterpiece or example of ingenuity in design and build but it sure feels good fixing broken stuff.
Results 1 to 2 of 2
02-15-2009, 01:58 PM #1
cast aluminum piece on mitre saw repaired
Last edited by Johnny; 02-15-2009 at 02:01 PM.MillerMatic 140 Auto-Set
02-15-2009, 03:34 PM #2
Its fixed is all that counts. Good job...BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below.