do any of yall have one of theese? i would like to put the power on mine so i can bend 2" .120 wall. but i cant spend the big bucks that hossfeld wants. i think i can build most of the parts what im wondering about is the ram. i could run the hydraulics to my truck that run the winch and balebed or off the tractor but i have been thinkin air ram i found one on ebay a 3"dia 21" stroke that has 700lb capacity i was thinkin of using that but im just thinkin out loud here.
thanks guys!!
Results 1 to 2 of 2
Thread: hossfeld bender hydraulics
-
08-06-2007, 05:40 PM #1
Member
- Join Date
- Jul 2007
- Location
- TEXAS
- Posts
- 92
hossfeld bender hydraulics
DYNASTY 200DX
SPECTRUM 625
MM 251
BWE
-
08-06-2007, 09:30 PM #2
Senior Member
- Join Date
- Sep 2005
- Location
- Salem ,Ohio
- Posts
- 3,650
I doubt if an air cylinder would do the job. Check out this guys bender. If you need a cheap hyd supply set one up like a log splitter with a briggs motor and a pump...Bob
http://www.mindspring.com/~jayk5/bender/Bob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Reply With Quote
