Pics of shop stove, roller, pond & house

[Portable Welder]

Here are some random pics. There is the shop stove that I mentioned over on Finneys post.

A roller I built about 6 months ago which will roll 36" wide plate, The rollers are made out of 3" DOM tube 1/2" wall, I'm not sure of all of its capacities but it will roll some pretty heavy stuff for a hand roller.
I'm guessing I could roll 36" of 10 Ga.
We arced a pc. of 1/2 x 6" to do a little test when it was done, You just have to do a little at a time.
I finally got around to painting it, I will put the 2nd coat of paint tomorrow.

There is my new house I'm building here at my shop.

Because I needed fill dirt for the house I decided to dig the pond which is rouphly 85' wide x 135' long and 26' deep. If you look you can see the posts that we put in for the dock.
I'm not in to walking up mucky sides so I'm going to install a ladder on the dock along with some type of swing.

It sure will be nice for me and the guys to jump in the pond after work on the 90 degree days.