My version of a welding cart.
Results 1 to 10 of 16
Thread: Double bottle cart
01-25-2009, 09:29 PM #1
Double bottle cart
01-25-2009, 09:33 PM #2
01-25-2009, 09:34 PM #3
01-25-2009, 09:45 PM #4
I really like the cart
especially the extension cord built in
Not exactly liking the red machine though
Had one nothing but problems
Nice ideas hope its ok i steal some though
01-25-2009, 10:02 PM #5
I have a saying on ideas:
"If you get your information from one place you have plagiarized, if you get it from many sources it research."
Last edited by smooth72; 01-25-2009 at 10:14 PM.
01-26-2009, 04:57 AM #6
Good job on the cart.
Just 1 change, the color, it blends in with Corvette. LOLBe safe
Give more than you get and
you will get more than ya need.
This is true for the good and bad
that life puts out.
01-26-2009, 05:20 AM #7
Weld Cart !!!
Hey Man, That is one real nice lookin' Cart !!
Just Watch that Gas Can in the back !!
I just bought a Lincoln 180, How's It Run the Spoolgun ??
Does It Run Good ??
Red Rules !!!
........................ Norm :
Sunrise Outside My Shop In Delhi, Ontario
- Arcair- K 4000 CAC.
- LN-25 Wire Feeder
- Lincoln Ranger 8- Engine Drive- CC\CV:
- Lincoln Power Mig 180C
- DeWalt Chop Saw .
- DeWalt Compressor - 13cfm, @ 100 psi.
01-26-2009, 08:10 AM #8Member
- Join Date
- Sep 2008
- Blacksburg Va.
Very nice cart well thought out.Kenny Compton
Cuttin,Grindin, Weldin, nutten better
01-27-2009, 09:37 AM #9Junior Member
- Join Date
- May 2008
Very nice cart. I like the hanger for the clamps and the basket.
Good call on the gas can. For gods sakes be careful and keep it well away from any welding or grinding. I had to stop my dad when he was welding within about 10 ft of the can. Normally he is very careful but in his rush to get the job done he neglected the can.
01-27-2009, 10:01 AM #10Member
- Join Date
- Dec 2008
- New York Suburbs
Hey Smooth! I saw a picture of your cart over on SFT and used it as part of a post on taking pictures of our work. Kinda tough over there because of the low limit on picture size. Those magnetic ground clamps stuck on the side of the tank kinda threw me. I'm a newbie to welding and hadn't seen them before. I thought they were part of the tank keeper -something to keep bottles upright? The SFT guys clued me in.
I really like the way you made the tank keeper. Much more secure than a chain! Guess I'll have to add a cart like that to my project list.
Thanks again - DrBob