I bought an old 1940's SB shaper a while back and it needed a stand. I wanted an old time round corner tray top so i made one from 1/8" steel some 1/8" x 2" flat and some 1/2" round bar. I put the flat bar on a 45* angle then rolled some 1/2" round in my bender for the top edge. Then filled in the corners with 3 pcs of steel and ground it all off after welding. Sort of how i used to do the Little Tykes molds except they were SS...Bob
Results 1 to 2 of 2
Thread: Round corner table top.
01-23-2009, 12:37 PM #1
Round corner table top.Bob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below.