Welding Table & some jeep goodies....warning picture fat!!!

[tasslehawf]

On your table, it looks like the casters are tacked on??

[bamacpl]

Looks good. What are you using for the pivot on your tire carrier. I built one a while back using a piece of cold rolled bar and a piece of DOM but it wants to gall badly, so I will need to cut that section off and weld on a new pivot.

1" trailer spindle from a tractor supply (Cal-Ranch)

[bamacpl]

On your table, it looks like the casters are tacked on??

yes, I wasn't sure how the pneumatic tires would work.....? so I tacked then for the trial period, they only lasted a week. I have since swapped them out for some solid ones! Much...much better!!!!!

[nocheepgas]

I like your Jeep tube doors and rockers. Want to fab some doors and tube fenders when I'm done building my tube bender. Here's a pic of my rockers and bumper:
Modified Warn rockers



Front Bumper

Recessed LED Lights

[TS-Off-Road]

Those LED "rocklights" are a cool idea.

[ace4059]

Nocheapgas,
where did you get those led lights from?

[Mr. Clean]

I like your Jeep tube doors and rockers. Want to fab some doors and tube fenders when I'm done building my tube bender. Here's a pic of my rockers and bumper:
Modified Warn rockers



Front Bumper

Recessed LED Lights

How about a little more info on this tubing bender you mentioned. I would like to see your plans. PM me if you would like, I don't want to high jack this post.

[nocheepgas]

Nocheapgas,
where did you get those led lights from?

I got them here: http://www.roundeyes.com/Products-LED_Lighting.html
I mounted them differently than they are designed. I beat the mounting panel/tab flat, drilled holes and a countersink (to allow for light dispersion) for the light and mounting holes and riveted them in place. It was a real bugger fishing them up to the ends of the bumper and holding them in place while I set the rivets.

[nocheepgas]

How about a little more info on this tubing bender you mentioned. I would like to see your plans. PM me if you would like, I don't want to high jack this post.

My bender is a real "Off the Wall" design. I wanted a powered bender but didn't want to spend the big bucks for hydraulics, so I'm building it to be powered by my winch! I have a concept drawing in my photobucket account:

http://s255.photobucket.com/albums/hh140/rivanisko4380/

[TS-Off-Road]

Using a winch cable to operate a tube bender!

Scary.