Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
 
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 7 of 7
  1. #1
    Join Date
    Oct 2006
    Posts
    17

    Default Straightening A-Arms

    I need to straighten the A-arms on the my Arctic Cat snowmobile. They are make of 1" OD x 5/32" wall low carbon steel. My thought is to heat the areas of the arm that need to be straightened and bending them straight. I am concerned about causing a weak spot where I heat. Anyone have any advice? I woud think I want it to cool slowly to keep it from becoming brittle.

    Thanks

  2. #2

    Default

    You will likely have a weak spot regardless, because the tube wall has stretched and deformed. Straightening the tube likely won't correct these issues unless the bend is very small.

    If they have already bent once, maybe it would be better to think about a way of preventing this form happening again, rather than just straightening the already weakened structure.

    If it is just round tubing I'd be inclined to replace the bent section with new material. You could either try using DOM in the same dimensions, or maybe even go to 4130- that would be nice.

  3. #3
    Join Date
    Jun 2006
    Location
    Maine
    Posts
    730

    Default

    Before you go modifying them to make them stronger think about this.... perhaps the A-arms were intentionally made the weak point because they are easy to replace... if you make them too strong, the next time you land wrong or catch a stump with a ski, you might end up ripping the mounts right off the chassis...
    Bobcat 225NT
    Cutmaster 52
    Lincoln Weld-Pak 100 buzz box
    Caterpillar TH63
    '07 Kawasaki ZZR600

  4. #4
    Join Date
    Dec 2006
    Posts
    612

    Default

    ....or getting hurt.

  5. #5
    turbo38t Guest

    Default

    I'd try to straighten them cold........if not a little heat won't hurt......a "little" is the key word . Dave

  6. #6
    Join Date
    Jan 2006
    Location
    long sault ontario canada
    Posts
    114

    Default

    i would cut them through the welds and splice in some new tubing
    smokin ana grinnin for 20 years
    Owner MARKS MOBILE WELDING
    trailblazer 302
    hobart suitcase mig
    miller 30a al spool gun
    laramy plastic welder
    brocco cutter
    pipe beveler
    all walter hand tools

  7. #7

    Default

    buy new a-arms.

    then buy armor for them.


    do you really want to risk failure at 40mph for a few hundred dollars ?


    same theory behind helmets.

    priceless head 20 dollar helmet

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Welding Projects

Special Offers: See the latest Miller deals and promotions.