Looking for som pics/ideas to make a 2:1 or 1:1 lever to move a shaft to engage a hydraulic pump on a crane truck. It was direct pill off the end of the shaft via a 5/16" solid end cable but we are reversing and pulling from the opposite side and the shaft is irreversible. So now the cable comes from the other direction and will have to be about 2" minimum above the shaft center and I need a way to pull it. I tried welding an arm on a bolt that went sraight up perpindicular from the end of the shaft but it puts an odd tension on the shaft and won't engage it. Dave
Results 1 to 10 of 15
11-13-2008, 04:19 PM #1turbo38t Guest
2:1 or 1:1 lever pics for PTO/Hyd Pump?