What amperage range w/ thumb control

[fun4now]

i think they will all be a bit frustraiting to get used to at first but there is no question they will be verry usefull once masterd.
this one looks like the best choice IMO and the one i will be getting at some point if i chose to get one. right now i dont do anywhere near enough TIG, much less out of position to worry about it. arc-zone caries them and i think CK makes one built into the torch, or maybee its some one else but here is a link to the arc-zone one. they are great people to deal with( IME ).
http://www.arc-zone.com/catalog/web_...6892375_530993

here's a pic for quick reference.

[SNAFU]

I have a lightly used one set up for a DX300 (14 pin) for sale if you want a used one. It came from Arc-Zone and has about 50 hours use. It is just like the one pictured above.

[fun4now]

cool how much $$ you looking to get out of it???

[SNAFU]

$145 + shipping
One of the velcro straps has a melted place where it was laid down on a hot piece. The unit is only about two months old and still under warranty. Still have the box for it. PM me if you want it