hints on running e71t-1 3/16 wire on 1/4 inch plate in vertical postion
Results 1 to 3 of 3
Thread: e71t-1
-
07-04-2007, 10:37 AM #1TAYLORMADE Guest
e71t-1
-
07-04-2007, 11:34 AM #2
Member
- Join Date
- Jun 2007
- Location
- San Diego CA
- Posts
- 32
wire welding
the wire that we use in the feild is no bigger than 5/32 and that is
NR-211mp lincoln wire
the other wire we use is NR-232 and that wire is .072
and the last one we fall back on is the good old 7018
1/8 inch is the all out weld in any spot
the wire you have sounds like ship yard welding that is where i
have seen wire that size
-
07-04-2007, 10:04 PM #3
Senior Member
- Join Date
- Jun 2006
- Location
- Calgary, Alberta
- Posts
- 377
I think you mean 3/32" wire, and that'd be mighty hot and fast! Sorry, I've only run an E71T-1 1/16" wire in the vertical position, and on 1/4" plate I think I'd have troubles knowing where to set the machine to avoid meltdown. I've only run 3/32" flux core in flat and horizontal positions.
Jonny
Dynasty 300DX
Esab PCM 1000
Reply With Quote
