I got a Millermatic 140 as the first welder ever and enjoy being able to fix and make.
The aluminum welding has progressed, a little bit, and there's hope.
Here's a spinner target I made and it works great. The bearings are stainless tubing:
Results 1 to 6 of 6
09-19-2008, 09:31 AM #1
spinner target- small second project
Last edited by Johnny; 09-19-2008 at 09:35 AM.
09-29-2008, 04:34 PM #2Junior Member
- Join Date
- Sep 2008
- Peoria IL
It looks good, what Caliber bullet are you shooting it with, it doesn't looking like it would take much more than a 22 to penetrate straight through.Our virtues and our failings are inseparable, like force and matter. When they separate, man is no more.
09-29-2008, 04:49 PM #3
Spectrum 625 X-treme
Hobart Champion 16 W/
Miller 8VS Suitcase
Miller 3035 Spool Gun
Tons of Tools
Laptop and Printer
Speakers in the Back for all to hear Sirius Radio!
09-29-2008, 08:38 PM #4Senior Member
- Join Date
- Sep 2006
- Abilene, Texas
Johnny, there is no limit as to what you can do. I'd hate to think about not having a welder since I can "fix" stuff that other people just look at and scratch their heads.Jim
09-29-2008, 09:09 PM #5
I like it.
Miller 140 w A/S
HF 90 Amp Flux Core
Dewalt Chop Saw
Smith O/A Torch
Ryobi, HF grinders
Harley Electra Glide Classic
10-02-2008, 04:03 PM #6
Got busy and ingnored my own posting- shame on me.
Thanks for the replies. Yesterday I shot the spinners at 50 yards regretfully only hitting the bigun 3 out of 5. This was only ever intended for use with "adult air rifles" and a .22lr would probably pop its cork. The small target is 7/8" and the large one is 1-3/8"
As far as this question:
"Why no stainless for the down lengthes and targets?" I am too cheap to use my very limited stainless stock and the solid steel upright could be beaten into hard/dry clay repeatedly.
Here's my favorite squirlling gun (air rifle) in .22:
After recently adding a 7-shot magazine and bit of bling using muriatic acid to remove blueing.
Last edited by Johnny; 10-02-2008 at 04:16 PM.