Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
 
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 2 of 2

Thread: 200 Millermatic

  1. #1
    Join Date
    Sep 2008
    Posts
    3

    Default 200 Millermatic

    Hi there, My name is Mike and would like to ask your help in solving my problem. I purchased a millermatic 200 and I was wondering if someone knew the jumper settings for the input voltage. I believe it is set for 550 and I need it at 220. I appreciate all input.

    Thank You

  2. #2
    Join Date
    Aug 2008
    Location
    Orange, TX
    Posts
    1,145

    Default

    Hey Mike,
    Welcome to the forum. A couple of us replied to your question in another thread but here's what we offered:

    For some reason Miller left out the jumper arrangement illustration in certain SN range MM200 manuals and refers the reader to the jumper arrangement label near the primary terminal strip. Once you download the correct manual for yours as cruizer mentioned - based on its SN - read it carefully as the jumper arrangement may be in the primary wiring section toward the front of the manual, in the wiring diagram toward the rear of the manual or you may be directed to the jumper arrangement label at the primary terminal board.
    Duane
    MM200 w/spot controller and Spoolmatic 1
    Syncrowave 180 SD
    Bobcat 225G Plus LPG/NG w/14-pin*
    *Homemade Suitcase Wire Feeder
    *HF-251D-1
    *WC-1S & Spoolmatic 1
    PakMaster 100XL
    Marquette "Star Jet" 21-110

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Welding Projects

Special Offers: See the latest Miller deals and promotions.