My tig torch is very light and the weight of its cable keeps pulling it off the welding table just about breaking the cup. A while back some guys posted
pics of a torch holder with a magnetic base. I think they were just for a horz flat surface. Then I had an idea to make one but a little more versatile. I took an inexpensive magnetic base, for dial indicaters, took the adjustable arm off leaving the tightening knob on. I then formed a piece of 3/8 round which fits the bore on the base to hold my torch. It can hold your torch or mig gun in just about any position and on round as well as flat steel. This might be helpful for people doing roll cages in the vehicle. Here is some pics.
Results 1 to 10 of 13
Thread: Quick useful helper
06-28-2007, 07:33 PM #1
Quick useful helper
Last edited by monte55; 06-29-2007 at 11:23 PM.