Snowplow reface

[aametalmaster]

I just got in a Meyers snowplow that needs refaced. As soon as i get the sheet rolled i will put up some pics...Bob

[admweld]

One plow i,m not a big fan of.Nevertheless good luck with your project.

[J hall]

I presume you are going to get it over rolled a touch so it will need to be pulled in tight?

[aametalmaster]

Yup i will be working my magic in the rolls. I will make it in 2 pcs so i can roll it rather then bend it in the press brake since its 91" wide...Bob

[J hall]

That's what I thought. I've never done a snowplow, but I've done several D9 Cat dozers. they are rolled to a smaller radius then tacked on the bottom and run up on something solid and tacked on top befroe welding out.
I was curious to see if the same method was applied to the plow.

[Sberry]

Did it from a flat sheet, rolled it on in place. Look at the last pic, blow some holes in the angles to let the water drain out.

[MMW]

Just cut out a cardboard template to give to the shop doing the forming. A lot of times plows or dozer blades aren't a perfect radius, especially if worn or bent, so a template will get you very close.