Heres a couple of pix to show you guys. The SS fan and airscrubber I made for a customer quite a while ago. The other stuff is a rear trailing arm off an offroad racing buggy that I've just repaired. First I did the coffin shaped bearing housing which the owner took away and fitted into the trailing arm. Then it came back to me to be welded. Only downside to doing it this way was his big tacks which left a couple of lumps. Have also repaired his front arms and front beam, but didn't get any pix. Will also be doing some chassis repairs at his workshop so will try to take the camera. Damaged front beam, front arms, nerf bar, chassis and rear arm. Thats motorsport.
Results 1 to 4 of 4
-
05-16-2008, 02:42 AM #1
Junior Member
- Join Date
- Nov 2006
- Location
- Auckland, New Zealand
- Posts
- 26
Acouple of small jobs from New Zealand
-
05-16-2008, 04:00 AM #2
Member
- Join Date
- Feb 2008
- Location
- California
- Posts
- 51
Looks good.
Is the thing in the first pic the airscrubber?
-
05-16-2008, 04:40 AM #3
Junior Member
- Join Date
- Nov 2006
- Location
- Auckland, New Zealand
- Posts
- 26
Yes. Air goes in one end, goes through a cabon media which takes some impurities out of it, and comes out the end I'm leaning on.
Originally Posted by krackle
-
05-17-2008, 01:30 PM #4
Junior Member
- Join Date
- Nov 2006
- Location
- Auckland, New Zealand
- Posts
- 26
Here are some pix of the car I took yesterday. Unfortunately the owner ground away the weld reinforcement in the join in the front beam. It looked quite pretty so I don't know why he did that. I hope it doesn't come back to bite.
Reply With Quote
