Well I finally put the finishing touches on the grille for my oldskool barstool. The whole thing was made from 16 gauge sheet. I just finished making the light mounts today. I used my brake to bend the mounts up on three sides, then welded a nut on the back of a boxing strip for the lights to bolt to. The mounts were then plug welded from the inside of the grille. I probably end up doing some pin striping on the top part once I dial in a design I'm happy with.
Results 1 to 9 of 9
Thread: finished barstool grille
Threaded View
-
02-09-2006, 02:43 PM #1
Member
- Join Date
- Sep 2005
- Posts
- 68
finished barstool grille
Reply With Quote
