for what it's worth, i made a lift for my meager shop. it's held up well lifting buckets as large as the 48" for the 325 cat. i made it about a foot wider than my trailer but the height limitations in the shop i'm in now make it a tight lift for bigger stuff. when i build a bigger shop i'll have a higher cieling and i'll just cut the beam off and add a couple of feet to the posts.
if i knew then what i know now i would have joined the beam pieces at a 45 deg angle or a step in either one, but like i said, it's held up fine. besides i NEVER get under anything lifted for any reason.
if you're interested, i can get you some measurements and a beam size.
Results 11 to 12 of 12
Thread: Need help/advice on shop A-frame
04-23-2008, 06:28 PM #11
overhead lift1 BEST 6 Y/O HELPER IN THE WORLD
2 VICTOR O/A TORCHES
LINCOLN SP 175 PLUS
4 EACH 20 TON JACKS
SEVERAL LESSER TON JACKS
LOTS OF HAMMERS MISC SIZES
BIG PILE OF MISC TOOLS
CLASS A CDL'S
C7500 FLAT BED
HOME MADE GANTRY CRANE
SOME GOOD COMMON SENSE (I THINK)
TRACTOR WITH NEW HEAVY DUTY LIFT POLE -- FIND MY THREAD
6 GOATS, 1 DOG, 1 DONKEY...
ON AND ON AND ON...
04-23-2008, 08:50 PM #12Senior Member
- Join Date
- Dec 2007
- National City CA
Splice plate like you added to the bottom is also used on top and the weld is only ground away on the flange. so a regular butt joint is fine.
the only critique I have on your lift is the size of the gussets. A little small, but I also don't know the capacity of the hoist system.Miller Syncrowave 200 W/Radiator 1A & water cooled torch
Millermatic 252 on the wish list
Bridgeport Mill W/ 2 axis CNC control
South bend lathe 10LX40
K.O. Lee surface grinder 6X18
Over 20 years as a Machinist Toolmaker
A TWO CAR garage full of tools and a fridge full of beer
Auto shades are for rookies