I just joined up for some advice on my new-to-me 180SD, thought i would share some of my MIG projects
Did a 4 1/2' X 8' trailer for my uncle used a stripped down mercury villager rear axle 3300lbs rated!, I swear you could park a tank in this thing frame is 3"x3"x1/8' square tubing! (i think i over designed it a lil)
My Go-kart for some fun! used a 11hp honda, comet torq-a-verter series 40 primary drive and a #60 chain final drive, hydraulic disc brake mercedes benz caliper and toyota hi-lux clutch master for the brake master. Thing is soo much fun!
Results 1 to 4 of 4
04-11-2008, 03:33 AM #1Member
- Join Date
- Apr 2008
- Toronto Canada
New to forum wanted to share some MIG projects
Last edited by Garage guy chris; 04-11-2008 at 03:52 AM.Garage Guy Chris
-Miller matic 210 w/ spoolgun
04-11-2008, 04:16 AM #2
Put a little shovel in front of that thing and LET R RIP!!!!!!!!!!I'm not late...
I'm just on Hawaiian Time
04-11-2008, 07:06 AM #3
Very cool. Keep the photos coming! And remember as a welder, nothing is overbuilt, unless it won't fall down.
TacMigWe depend On:
Miller | Esab | Lincoln | Fronius
Baileigh | Drake | Eagle | Knuth
Victor | Harris | Smith | Bessey
Snap-On | Hilti | Ingersoll Rand
Burco/Koco | Onan | BobCat
Tracker | Infratrol | AmeriCast
We belong to or support:
American National Standards Institute
American Welding Society
The Welding Institute
Fabricators & Manufacturing Association Int'l.
Anderson & Co. LLC
09-04-2008, 09:31 PM #4
I could get into some serious trouble with that Kart!