Does anyone here do alot of powdercoating on iron railings? I would like to know what is the best way to treat the steel before coating. I do fabricate alot of railing and I usaually hand paint them, and just recently customers have been wanting powder. I tell them that their is no guaranty.
Results 1 to 3 of 3
Thread: Powder Coating;
05-24-2007, 05:28 PM #1Member
- Join Date
- Feb 2007
- Clifton, NJ
05-24-2007, 06:05 PM #2
You will probably want to use a Chromate rich epoxy primer applied over fresh grit blasted iron. PC isnt the best for corrosion since it seals out oxygen from the primer and doesnt let the anodic action take place with the chromates if it gets scratched. Maybe look at a sprayed Acrylic Enamel (with hardener) topcoat. Its got better adhesion and usually better UV resistance.
-Aaron"Better Metalworking Through Research"
Miller Dynasty 300DX
Miller Dynasty 200DX
Miller Spectrum 375 extreme
Miller Millermatic Passport
Miller Spot Welder
Motor-Guard stud welder
Smith, Meco, Oxweld , Cronatron, Harris, Victor, National, Prest-o-weld, Prest-o-lite, Marquette, Century Aircraft, Craftsman, Goss, Uniweld, Purox, Linde, Eutectic, and Dillon welding torches from 1909 to Present. (58 total)
05-24-2007, 06:33 PM #3
I quit using powder coat on my outside metalwork because you can't get in the nooks and crannies with the pc and it will rust bad. I went back to painting the parts....BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below.