Just looking for opinions on the new format. Kinda wish they had left it alone or merge it all into one. I can tell want I want to read or reply to. If not just pass it by. Hope we don't get it as complicated as a tax form. Just my 2 cents.Jump through hoops all day long to keep customers happy & that's fine but I want this board for relaxation,learning & helping if I can, but not if I gotta chase all over hells half acre to do it.
Results 1 to 4 of 4
Thread: Opinions on the new Format
02-26-2008, 06:33 PM #1
Opinions on the new Format
02-26-2008, 06:49 PM #2
Myself I don't see any difference from before 'cause I was enrolled in both and went from one to the other all the time.
It will only change when the Motorsports gets going.
Other than maybe both crowds tending to mix it up a little more now.
Mainly it's just easier to moderate and less confusing for newbies.
Miller Dynasty 700...OH YEA BABY!!
MM 350P...PULSE SPRAYIN' MONSTER
Miller Dynasty 280 with AC independent expansion card
Miller Dynasty 200 DX "Blue Lightning"
Miller Bobcat 225 NT (what I began my present Biz with!)
Miller 30-A Spoolgun
Miller Spectrum 300
Miller 225 Thunderbolt (my first machine bought new 1980)
Miller Digital Elite Titanium 9400
02-26-2008, 07:15 PM #3
I dont mean to sound stupid but I do not see any change in the board. The only thing I did see was Motorsports and Gearhead listed under Industries & Interests. Everything else is still the same old board, of course I am only enrolled in the welding board and not the Motorsports.Ken
What else is there besides welding and riding. Besides that
Miller Thunderbolt XL 300/200 AC/DC
Hobart Handler 187
Dewalt Chop Saw
4" Air Grinder
Rigid Drill Press
Kellogg 10hp Air Compressor
02-26-2008, 08:00 PM #4
Just a start?
A little different in that they now have a "discussion" board. Not sure but it may be a result of all us yapping on non project subjects a good deal of the time. Perhaps Miller is pointing us yappers to the "discussion" board to do just that in hopes the project board will be a project board. When they first announced changes to the board I was a tad concerned it would end up like the Hobart boards which if you haven't been there is a complete cluster &$%# and your better off not going there at all. So with that said, maybe Miller needs a pat on the back for giving all us yappers a place to yap..??
TacMigWe depend On:
Miller | Esab | Lincoln | Fronius
Baileigh | Drake | Eagle | Knuth
Victor | Harris | Smith | Bessey
Snap-On | Hilti | Ingersoll Rand
Burco/Koco | Onan | BobCat
Tracker | Infratrol | AmeriCast
We belong to or support:
American National Standards Institute
American Welding Society
The Welding Institute
Fabricators & Manufacturing Association Int'l.
Anderson & Co. LLC