I started a new project today. I am making flowers with hammered copper petals TIG welded to carbon steel stems. My question is do I need to worry about copper fumes the same as I would worry about galvanized steel fumes when welding? There is not a lot of welding on each flower but I might start to do a lot of these and I was just wondering if my wife is going to find me dead in the shop one afternoon.
Thanks in advance for any advice.
Results 1 to 9 of 9
Thread: copper fumes?
04-23-2007, 10:45 PM #1
copper fumes?If you had fun making it, you did a good job
Miller Syncrowave 200
Hobart Airforce 250A
and a LOT of hammers