Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Profile Picture
Oldgrandad
Senior Member
Last Activity: 02-12-2018, 09:18 AM
Joined: 07-08-2016
Location:
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Oldgrandad
    replied to mm185 NOT WELDING
    Thanks for the links Bob. Got a new selector coming from weldfabulous should have it in a couple days. Yeah those drive rollers look like 'Do those really work?' but that do and they work good. I have less feed issues with that machine than my other two....
    See more | Go to post

    Leave a comment:


  • Oldgrandad
    replied to mm185 NOT WELDING
    Contacts are a little fried so clean them up put a little grease on them put it all back together. Number 3 still not good but she'll work on the rest, so back to work for her. I'll order a new selector and the problem should be gone.
    See more | Go to post

    Leave a comment:


  • Oldgrandad
    replied to mm185 NOT WELDING
    So I turned her on set on 3 got gas and rod but not spark. Tried Danny's suggestion and moved the selector about and bam she welds. works on all but 3, so I strip her down to check her insides, lots of dirt. Give her a good blow job and then take a close look. The relay is doing it's thing. Take a peek...
    See more | Go to post
    Last edited by Oldgrandad; 02-02-2018, 05:32 PM.

    Leave a comment:


  • Oldgrandad
    replied to mm185 NOT WELDING
    Well tore into the welder today. Good news it works now, bad news I need a new selector switch. When set on 3 she only welds sometimes. In all other positions works as she should. The contacts were a tad burnt here are the piic's.
    See more | Go to post

    Leave a comment:


  • Oldgrandad
    replied to mm185 NOT WELDING
    Thank you I will try all of your suggestions when I have a free moment hopefully that will happen Friday.
    See more | Go to post

    Leave a comment:


  • Oldgrandad
    replied to mm185 NOT WELDING
    This machine has 2 push buttons there I pushed both, no change. Been busy today and haven't opened her up yet. Any other ideas?
    See more | Go to post

    Leave a comment:


  • Oldgrandad
    started a topic mm185 NOT WELDING

    mm185 NOT WELDING

    OK guys whats my problem? I mean with the machine. Pull the trigger, get gas and wire but no sparks. Serial #KJ288399. I haven't taken the cover off yet. My guess is a relay. I'll dig into it tomorrow, but where do y'all think I should look first. Thanks in advance for leading me in the right direc...
    See more | Go to post
No activity results to display
Show More
Working...
X