Announcement

Collapse
No announcement yet.

User Profile

Collapse
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Andrew J 649
    replied to TIG filler wire size?
    Thanks ryanjones2150 on the filler opinion. Your question about joint design sounds like a new discussion/topic, but it sounds like you don't approve. Keep in mind, the two front vertical corners are press brake formed, and the bevels are 2/3 depth of the material and 2" long x3 per joint.
    See more | Go to post

    Leave a comment:


  • Andrew J 649
    replied to TIG filler wire size?
    I was just going to start a thread when i found this, so i thought i'd add to it .
    I'm in the middle of doing a large job all in 1/4" 5052 plate with some 3/16 too. Its 25 planter boxes (i know that might be a head scratcher for some.. but its what the architecture firm specified for a...
    See more | Go to post

    Leave a comment:


  • I hear that ryanjones2150. I really like the idea of one for all and the Diamond Ground products 2% Lanth (blue) that i got two weeks ago have been working better than anything i had previously. Unfortunately, i think for what I'm currently doing (lots of 1/4" 5052), the "tri-mix" is...
    See more | Go to post
    Last edited by Andrew J 649; 04-23-2016, 01:04 PM.

    Leave a comment:

No activity results to display
Show More

Profile Sidebar

Collapse
Profile Picture
Andrew J 649
Junior Member
Last Activity: 04-24-2016, 09:25 AM
Joined: 07-04-2014
Location:
Working...
X