Announcement

Collapse
No announcement yet.

User Profile

Collapse
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • kevin
    replied to Flux vs Shielded Flux Question
    if you are just starting out, stay with the mig, the dual shield with co2 is great, but not really where you should be, if you are doing bigger welds it would be ok, but your machine wont keep up with it if you start pounding out the wire, plus, as mentioned, costly. dont under estimate the mig process,...
    See more | Go to post

    Leave a comment:


  • most suppliers will have shorts, lets say someone orders a 16 foot piece of angle iron, they will be charge for the 20 foot stick, plus the cut, then the 4 foot piece goes to the short pile to resell, not all yards offer the short piece along with the piece that is ordered, unless the customer ask for...
    See more | Go to post

    Leave a comment:


  • kevin
    replied to "Vintage" C Channel welding
    instead of grinding, try using your torch to clean off the rust, just heat it where the weld will be, cuz, badly rusted steel is usually pitted, and grinding it takes off too much steel
    See more | Go to post

    Leave a comment:


  • kevin
    replied to Help with 1/8" 6010/6011
    some mention of brands, has any one recently looked at the logo,made in xxxx, which used to be america, on some suppliers, it will say, assembled in america with imported components. ive stopped buying from airgas, their rods have gone to the worst. i have a feeling that airgas is like home depot with...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More

Profile Sidebar

Collapse
Profile Picture
kevin
Senior Member
Last Activity: 01-25-2017, 05:41 PM
Joined: 06-07-2009
Location: greenfield new hampshire
Working...
X