Announcement

Collapse
No announcement yet.

User Profile

Collapse
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Miller Kevin
    replied to miller 250x hot start
    What it does is give a little more power on the starts which in most cases is fine in particular on thicker materials. It can however cause issues on very thin materials or if you are running a small diameter wire such as .023. With the unit you have the start performance is actually very good without...
    See more | Go to post

    Leave a comment:


  • Miller Kevin
    replied to miller 250x hot start
    rspiger, on the unit you listed you would need to clip D-1 diode on the control board to disable the hot-start. It would be located right along the edge of the board in the upper right hand corner.

    Kevin...
    See more | Go to post

    Leave a comment:


  • romesnow,

    The weld current is supposed to transfer to the wire at the contact tip. It looks like in this case it is transferring at the drive roll instead and there are only a few things that I know of that will cause this.

    1) Poor connection where gun plugs into the unit....
    See more | Go to post

    Leave a comment:

No activity results to display
Show More

Profile Sidebar

Collapse
Miller Kevin
Miller Kevin
Moderator
Last Activity: 02-16-2017, 03:58 PM
Joined: 09-01-2005
Location: Appleton, WI
Working...
X