Announcement

Collapse
No announcement yet.

User Profile

Collapse
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • MMW
    replied to Welding and Metalworking Table
    Yes on the x brace but it can also go from the top of one leg to the bottom of the other leg on the same side. Like an upright x on each of the four sides or a laid down x about a foot from the floor.

    I am thinking the tubing you used for legs is just to lightweight & you will be chasing...
    See more | Go to post

    Leave a comment:


  • MMW
    replied to My wp9 water cooled torch broke...
    You should not run a water cooled torch without water. It will over heat very quickly. The design for water & air cooled torches are different.
    See more | Go to post

    Leave a comment:


  • MMW
    replied to Welding and Metalworking Table
    Can you post a picture? That would be most helpful. It may be a bad design or it could also be the legs are not sturdy enough.

    If you shake it with your hands & let go does it keep shaking for a moment? Maybe an x-brace in the horizontal plane about a 12" from the bottom might...
    See more | Go to post
    Last edited by MMW; 07-16-2016, 04:34 AM.

    Leave a comment:


  • MMW
    replied to Trailblazer 250 G PROBLEMS
    If you haven't seen it this is my thread. It confirms what you already now know about bypassing the exciter board with wire 20 & 29 & leaving the rest of the board connected. Since I've done it many years ago it has been fine. Never had the issue again.

    http://www.millerwelds....
    See more | Go to post

    Leave a comment:


  • MMW
    replied to Advice Needed To Prevent Warping
    If the legs are pulling in towards each other then cut a pc. that is a tight fit at the open end & tack it in before welding. After welded & cooled, remove it.

    Straightening after the fact you can heat the tube on the opposite side of the weld to pull it back. This is somewhat...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More

Profile Sidebar

Collapse
MMW
MMW
Senior Member
Last Activity: 07-18-2016, 07:23 PM
Joined: 09-08-2005
Location: northern NJ
Working...
X