Announcement

Collapse
No announcement yet.

Gauge confusion

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Gauge confusion

    Hi all,
    I had a gauge that measured CFH which broke. The guy at the welding shop sold me a gauge that measures L/min. I found the conversion rate to be 2.2 or something, which is fine.

    But then I noticed that the lowest L/min mark on the gauge was 5, which is around 10cfh. Anything below that, I won't know what the flowrate is...I can't afford a floating ball setup. Should I return this gauge?

    Thanks

  • #2
    If it were me I would take it back and get a " floating ball guage" (flowmeter) from HTP for about $45, I have one on my tig setup and seems to be of good quality.
    Regards, George

    Hobart Handler 210 w/DP3035 - Great 240V small Mig
    Hobart Handler 140 - Great 120V Mig
    Hobart Handler EZ125 - IMO the best 120V Flux Core only machine

    Miller Dynasty 200DX with cooler of my design, works for me
    Miller Spectrum 375 - Nice Cutter

    Comment


    • #3
      Thanks, I didn't know you could get them that cheap!

      Comment

      Working...
      X