Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Gauge confusion

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Gauge confusion

    Hi all,
    I had a gauge that measured CFH which broke. The guy at the welding shop sold me a gauge that measures L/min. I found the conversion rate to be 2.2 or something, which is fine.

    But then I noticed that the lowest L/min mark on the gauge was 5, which is around 10cfh. Anything below that, I won't know what the flowrate is...I can't afford a floating ball setup. Should I return this gauge?

    Thanks

  • #2
    If it were me I would take it back and get a " floating ball guage" (flowmeter) from HTP for about $45, I have one on my tig setup and seems to be of good quality.

    Comment


    • #3
      Thanks, I didn't know you could get them that cheap!

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.