If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
How much can you lift with that hoist? Nice job! That slide out drawer is great idea.
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
HOW did you make that slide out compartment? The pic was too small on my computer to see what you were wrapping the leads around. Tubing? Welded to the trailer floor with the machine in the middle? Trailer AND setup is AWSOME!!!!!!! Something for us newbie trailer maker wannabees to look up to!!!
the drawer is made with 1 1/4 angleiron and is welded down 6 inches from the frameand it is 3 ft wide and 6 ft long.we didnt put rollers on it so it slides on the angle frame.i put bar soap on it and it slides real easy the lead holders are made with 1 1/8 square tubing with 1 inch welded to the floor so we can take the leads off and they will stay on the holders.we have a table that is 24 x 24 thats sets on the railing anywhere on the trailer for a 6 x 10 trailer we have everything we need on it.good luck with your trailers.feel free to contact me for any questions you might have
miller bobcat 250 wc 115a spoolmatic 30a centery 250 mic 2 lincoln 225 stick a 1954 hobart portable welder w/ willies jeep engine
Thanks so much for explaining that. Question: "Bar soap to slide the drawer."
Do you think "Irish Spring" would be better than "Dove" since it's got the green and white stripe??? Sorry, Couldn't resist, 1st time I heard using soap!!! Why don't you use grease? You wouldn't get your hands dirty, since it's underneath, right?