Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Idle Problem Miller AEAD 200LE

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Idle Problem Miller AEAD 200LE

    Just purchased the above unit. Great condition except it wont idle down after stopping the bead. Stays at the welding RPM. I was told by the seller that it had a bad circuit on the board. Does anyone have a similar machine that has experienced the same problem?

  • #2
    First thing I'd do is check the voltage at the battery when it's running, see if it's charging or not (should be 13+ volts). This happened several times with my trailblazers (Onan engines), every time it was the rectifier/voltage regulator fried, battery voltage (12 volts or less) by itself wasn't enough to operate the idler electromagnet.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.