Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Advice needed

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Advice needed

    Hello all, I am in the proccess of learning to TIG weld. I am in the UK but have found US sites to be the best for advice and information. Can someone give me some advice on welding thinner metal (22 gauge mild steel). What size tungsten and filler rods should I use and what Amperage Range should I be using.Sorry if these are real basic Questions.

  • #2
    I would try either 1/16" or .040 tungsten, Filler should be no thicker than 1/16" I would prefer.045. I will convey a basic rule of thumb for amperage, 1amp=.001 of base metal thickness.

    Weld well, weld safe,
    pjseaman

    Comment


    • #3
      Thanks for that pjseaman

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.