Announcement

Collapse
No announcement yet.

Spool Gun Problem

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Spool Gun Problem

    Why does my wire burn before it comes out the contact tip?

  • #2
    too high on the voltage ....too low on the wire speed or feeding problems......I'm sure there are more.......more info would help as well.
    Good Luck,
    Mike
    George W. Bush was saving your butt whether you liked it or not!
    Fear is temporary, regret is forever
    HH210 with SG

    Comment


    • #3
      I assume you are using alum wire? Make sure the hole is the proper size and make sure the wire slides thru the tip hole when the tip is off, if it is tight go to the next size tip. I ran into problems with the proper size tip it seems they were made too small. Try some more wire speed....Bob
      Bob Wright

      Spool Gun conversion. How To Do It. Below.
      http://www.millerwelds.com/resources...php?albumid=48

      Comment

      Working...
      X