Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Custom cycle frames

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Custom cycle frames

    I am new to the board and was wondering if anybody has some good prints for a custom motorcycle frame with a soft tail rearend. I can find several rigid plans but nothing with any kind of rear suspension.

  • #2
    Sent you an email. Drawings too big to post.


    • #3
      Thanks To makin sparks

      Thanks for the plans. I was wondering what size tire I will be able to run with this swing arm, I am looking for plans that will allow me to run a large after market motor and at least a 200mm tire on the back bigger if possible. As I said before I am new to this whole frame thing. However I have a friend that has been welding dragster frames for about 15 years and is wanting to help me get my project started.

      I would appreciate any help you have to offer

      Thanks again

      AKA smokin_gloves


      • #4
        MS -

        What type of frame is on your plans? I need to build a frame for an upcoming project, and have plans for several customs. I will have to make drawings of mine, as it will be for mating an engine and transmission that were from two different model bikes. But, it's always handy to compare what's out there.



        • #5

          The drawings I sent are for a 180 tire. You just need to open up the dimension between the axle plates on the swingarm to accomodate the 200.


          • #6
            Chopper builing

            If you don't already know about them you may want to check out these sites -





            • #7
              And check out Chopper Underground Forum at This is a good place to start. Lots of discussion and play by play threads to check out.

              Last edited by envano; 05-01-2007, 02:32 PM. Reason: Invalid URL


              Special Offers: See the latest Miller deals and promotions.