If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The pic worked & it looks great. Nice job with the bowtie in there.---MMW---
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
Hobart Handler 210 w/DP3035 - Great 240V small Mig
Hobart Handler 140 - Great 120V Mig
Hobart Handler EZ125 - IMO the best 120V Flux Core only machine Miller Dynasty 200DX with cooler of my design, works for me
Miller Spectrum 375 - Nice Cutter
thats a fine looking rack. i too would like a lil better look at the mounting part, any chance of a close up of that???
i been planing on addig some thing similer to mine and was planing on running the pipe down into the corner hole then adding some bracing back out onto the bed rail. your setup look verry clean, i would rather go your way.
rhag, welcome to the site.
thanks for the help
hope i helped
feel free to shoot me an e-mail direct i have time to chat. firstname.lastname@example.org summer is here, plant a tree. if you don't have space or time to plant one sponsor some one else to plant one for you. a tree is an investment in our planet, help it out.
I like the idea of using the existing stake pockets. Something for others to keep in mind is that if you are going to be carrying heavy loads, it is probably better to use the longer mounting brackets. I'm not sure that the stake pocket would keep a heavy load from bending the headache rack forward under hard braking.