If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have done this many of times back in high school. We were using 6011 or 6013 rods on a Miller welder set to 80A and some Tig rods. Basically we started the arc with the stick and then pulled it back till the arc was just about gone, then layed in the Tig rod.
Takes some practice, but can be done easily enough. Good luck.
We were taught this trick to help repair some of the shop stools instead of brazing them with the torches. (Our Tig welder didn't work half the time.)
Last edited by blybrook; 11-07-2006, 02:23 PM.
Reason: Spelling Error