If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
These should work if you like them. Disregard the reference to me making a drop in box. If you use this, the upper section will bolt to existing holes, you will need to put the legs on the lower one so that it fits into the existing tray. You will also need to extend the axel about 1" or so to clear the wheels. If you want to see pictures of it completed do a search un my username as there are recent pictures of the setup on my MM210.
Hobart Handler 210 w/DP3035 - Great 240V small Mig
Hobart Handler 140 - Great 120V Mig
Hobart Handler EZ125 - IMO the best 120V Flux Core only machine Miller Dynasty 200DX with cooler of my design, works for me
Miller Spectrum 375 - Nice Cutter
I built mine based on Georges design with a twist. I didn't want to mess around with the axle. I made the lower part to fit into the lower. It was pushed out a little to avoid the wheels. I only use 120cf and 80's on it. Larger ones will need to mess with the axle.