Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Grinder stand and Latest project

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Grinder stand and Latest project

    I finally got a picture of my grinder stand I built several months ago. Also just finished the reciever hitch project today. Would have gotten some closer up photos of the reciever hitch but didn't want anyone laughing at the welds. A goose neck ball will drop down the center tube from the top. Actually they are not to bad. All parts were from the iron pile so cost was vilch.
    Attached Files
    Last edited by Pitalplace; 10-05-2006, 04:17 PM.

  • #2
    Why would we laugh, we all started in the beginning. Nice job...Bob


    • #3
      one word of caution......once you start building stuff for your tractor, there is absolutely no end to me, I have a 40hp implement and a 60hp skid steer. everytime I finish one attachment, I think of three more to build!!

      Have fun building...SSS


      • #4
        Nice work.... Keep it up


        • #5
          Nice job ... looks good
          glad to see you are having fun making things.



          Special Offers: See the latest Miller deals and promotions.