If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
...if you know that mid weld, you are on fire and still finish the rod
...if you feel a molten slag ball fall down and land on your arm/leg/neck and you shimmy around trying to get it off without breaking the arc
I have used carbon rods to fill worn out hitch pin holes. Put the carbon rod in the hole and weld around till the hole is full to your standards and pull the rod out and you have a perfectly round hole you dont have to try and drill
Only got to page 32, but gotta add mine........
YMBAWI: your company installs a new time clock that is fingerprint operated, and you have to use a pin pad instead because it won't read your prints
YMBAWI: your changing your 1 yo daughters diaper and you wonder if her diaper rash cream will soothe the flash burn on your arm (between the bottom of your shirt sleeve and top of glove, inside left arm)
YMBAWI: the door bell rings at 3:22am, because your buddies were rock crawlin and broke the jeep again and need you to weld it back together so they can get to work in the morning, or you have to put the TB275 and some 6011 in the truck to go fix the jeep broke on the rock/in the mud
YMBAWI: your wife buys a beautiful brand new pair of red wing boots, but you have her take them back because they have laces, (and we all know laces get expensive)