Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Miller Spectrum® 375 or Hobart Airforce 400

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Miller Spectrum® 375 or Hobart Airforce 400

    Shopping for plasma cutter in this range. I understand that these are the same manufacturer these days. Does it matter which one for quality? I am also considering the Hypertherm 380. Any advice? thanks

  • #2
    Originally posted by rgammie
    Shopping for plasma cutter in this range. I understand that these are the same manufacturer these days. Does it matter which one for quality? I am also considering the Hypertherm 380. Any advice? thanks
    Of the three you mentioned I would get the one you can get for the best price. I went with the Specturm 375 but either of the others would have been just as good I think.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.