Announcement

Collapse
No announcement yet.

Got some huge transformers! Will they work?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Got some huge transformers! Will they work?

    I got these from a street light that fell over and am wondering if I can make a welder with them. I'm not sure if they are 220 or what anybody know if and how I could wire them up? Thanks!
    Attached Files

  • #2
    Light Ballast transformers are very custom application devices

    Find the manufacturer's name and part number if possible and look it up. But.. I would suspect those are high pressure sodium light ballasts...

    Here is a link to such a device ... picked one of the larger ones at 1 kw... secondary open circuit voltage .. 435 volts.. secondary current 7 amp category...

    typical spec...
    http://www.usa.lighting.philips.com/...0W/71A8743.pdf

    Very dangerous output voltages and not enough current capability..

    Suggest you sell the copper and put that return toward a proper welder.. Also I can see impact damage to some of the windings...
    Last edited by dandeman; 03-23-2015, 08:11 AM.
    Hobby Welder for about 32 years
    Hobart 190 MIG with SpoolGun
    Hobart AirForce 700i Plasma Cutter
    Hornell Speedglas 9000X Helmet
    295A AC Buzzbox (what I learned on)
    Miller Bobcat 225, factory propane option, also serves as my emergency power generator
    Dandeman's Toy Page

    Comment


    • #3
      Was it your street light? the city or power company may be looking for it. Just sayin...Bob
      Bob Wright

      Spool Gun conversion. How To Do It. Below.
      http://www.millerwelds.com/resources...php?albumid=48

      Comment


      • #4
        It will be cheaper to buy a used welder

        Comment


        • #5
          It's not a welder, likely won't ever be a welder. Re purposing it as a boat anchor might work.
          Dynasty 280DX
          Bobcat 250
          MM252
          Spool gun
          Twentieth Century 295
          Twentieth Century 295 AC
          Marquette spot welder
          Smith torches

          Comment


          • #6
            never thought I'd be more inclined to view a 120v welder/trailer thread until now.
            Ed Conley
            http://www.screamingbroccoli.net/
            MM252
            MM211
            Passport Plus w/Spool Gun
            TA185
            Miller 125c Plasma 120v
            O/A set
            SO 2020 Bender
            You can call me Bacchus

            Comment


            • #7
              Transformers = Bad Idea

              In the interest of life safety you should scrap them. Transformers are either step up or step down voltage depending on the windings and configuration. They are design specific. I have a much longer real life story about 480v street lights from when I worked for the power company in Jacksonville, Florida if you want to PM me it was literally a shocking story.

              Comment

              Working...
              X