Announcement

Collapse
No announcement yet.

Low budget bucket patch

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Low budget bucket patch

    Here is what I did for a guy who doesn't have money but put a hole in his bucket. The floor is very thin so I just put a 1/4" plate over the top of what was there. This thing was repaired before by someone who had no clue. They actually put a floor in it & welded it to the bottom of the edge behind the shanks so the step from the edge to floor was on the inside. You can see the wear bars are worn through plus the shape of the bucket is all wrong.

    I hate doing stuff like this but again either I do it or someone else does. Welded fully around plus a few plug welds. I know it won't last long in heavy use but he's hoping to get some better work & have me rebuild it in the future.

    Name:  8fb7e0dc55013ff53e922839762b620d.jpg
Views: 1
Size:  122.6 KB
    Name:  118e58b745d624945228780fdcdcfd43.jpg
Views: 1
Size:  123.2 KB
    Last edited by MMW; 03-30-2014, 12:44 PM.
    MM250
    Trailblazer 250g
    22a feeder
    Lincoln ac/dc 225
    Victor O/A
    MM200 black face
    Whitney 30 ton hydraulic punch
    Lown 1/8x 36" power roller
    Arco roto-phase model M
    Vectrax 7x12 band saw
    Miller spectrum 875
    30a spoolgun w/wc-24
    Syncrowave 250
    RCCS-14

  • #2
    MMW, You forgot to extend the wear bars up to your new plate, I think he could have gotten a couple hours of digging out of them before their completely gone.

    I hear ya.

    We do our best to push them in the right direction but if they don't have the money what can you do.

    I had to work at a car wash last night, I repaired the tire guide 2 years ago and he waited until it completely broke before he had me replace it, so He had to pay
    $ 120.00 hr. for 4 hrs

    Comment

    Working...
    X