Announcement

Collapse
No announcement yet.

my welding table

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • my welding table

    Name:  f4c55d259e3bc204139c2ff9497f4941.jpeg
Views: 1
Size:  34.5 KB

    I enjoy looking at everyones welding table design and thought I would share mine. 1 1/2' top machined flat. Sides are all machined to make square. The clovers were lasered out at the steel company. This is the best investment I've made right next to my miller!
    Last edited by beav; 01-24-2014, 05:32 PM.

  • #2
    That looks too nice to use. Great job...Bob
    Bob Wright

    Spool Gun conversion. How To Do It. Below.
    http://www.millerwelds.com/resources...php?albumid=48

    Comment


    • #3
      Thanks! I think I stared at it a week before I would set anything on it!

      Comment


      • #4
        Are you gonna use it ?? That top should be hangin on a wall ! Awesome ! That probably cost as much as a machine .

        Comment


        • #5
          I use this daily now. That first little scratch was difficult but I couldn't afford to spend that money to just look at it..lol. Quite an uprade from the 4' x 4' table I was working on! I do a lot of large weldments that take up this whole top!

          Comment


          • #6
            That sure is pretty but I have to ask why it looks wavy. When I first looked at the picture I thought was wavy until I read where you said it was flat. Are the clover shaped holes just for clamping things or are they clover shaped for a specific reason?

            Comment


            • #7
              It must look wavy from the reflection of the machine passes. They only used a 5" tool in the machine to mill it down. And yes the clovers are only in there for clamping reasons. That's also why I went with such a thick plate. All the cutouts would make a thin top pretty weak when you have so much weight on it.

              Comment


              • #8
                Very nice top. What did you have to drop for it if you don't mind sharing.

                Comment


                • #9
                  The top was around $1250 and that included all the clovers lasered out

                  Comment


                  • #10
                    Thanks, I have been trying to get a feel for something just like this.

                    Comment


                    • #11
                      Just happened to see this thread,and seeing the table,that is an excellent job you did there

                      Comment

                      Working...
                      X