Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Skid Steer Forks

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Skid Steer Forks

    Converted an old manure fork bucket to a set of adjustable fork lift forks for a skid steer for my Dad. All materials except snap rings and paint were laying around on the farm.

    Manure bucket
    Fork lift forks
    10" C-Channel
    1/2"x4" Bar
    1/4"x1 1/2" Bar
    1 1/2" Round bar (shaft)
    2-5/8" Square Nuts
    Snap rings

    7018 Rods
    Cutting Torch
    Miller Bobcat 225 lp
    Attached Files

  • #2
    Very nice. You will wonder why you never had a set before.


    • #3
      Looks nice. Pallet forks are handy as h e l l.


      • #4
        Just need to add more A$$ in counterweights now... lol


        Special Offers: See the latest Miller deals and promotions.